All laid out on the dining room table.
New chassis mounts for the rotoflex suspension. 
Loads of nuts and bolts.
My favourite bit so far - Susuki GSXR 750 K4 motorbike throttle bodies!
New rear drive shafts to replace the rubber doughnut rotoflex ones.
GT6 front uprights.
Alloy front hubs.
2 comments:
When you fit the front hubs, and you are seating the bearing tracks in those hubs...Use loctite on them, plenty of it, then heat the hubs in an oven to expand the loctite. Don't ask why.
Just do it :)Use a press to remove them in the future.
P.S for the rear hubs, advise using old used ones. Check the shim face on the inner end of the stub for mange from previous efforts to remove them.
Post a Comment